Serrated anti-slip elements (serrated)

Despite the fact that the lattice flooring already in the standard version has excellent anti-slip characteristics (especially for welded flooring due to the twisted cross bar), in some applications it is necessary to provide additional lattice protection against slipping. In such cases, the lattice flooring can be made of a strip with anti-slip teeth.

Types of anti-slip teeth:

S4   - tooth " saw " - gives the maximum non-slip effect.
S5 and   S6 - Two anti-slip options such as " trapeze " They have the same anti-slip effect and differ only in manufacturing technology. The S5 tooth is more common

ATTENTION :
When choosing a lattice flooring of the SERRATED type, it is necessary to take into account the reduction factors of the maximum allowable loads. You can find these coefficients in the Technical Handbook in the « Load Tables »

Recommendations for choosing a lattice floor with anti-slip teeth

Lattice flooring of the SERRATED type should be used where there are conditions of increased risk of slipping, for example, in places where lubricants, emulsions, possible contamination or icing, etc. are used. SERRATED decking is also used in cases where the platforms are installed not in a horizontal position, but at a certain angle.

Example of anti-slip tests in accordance with DIN 51130

Anti-slip classes provided for in DIN 51130

Degree mounting angle Relevant anti-slip class
6-10 r9
10-19 r10
19-27 r11
27-35 r12
> 35 r13

Correspondence of anti-slip types of anti-slip class according to BGR181 *

Degree of mounting angle Lattice type Degree of mounting angle
Welded Pressed
r9 without teeth without teeth  
r10 without teeth s5, s6  
r11 s5, s6 s4  
r12 s4 s5, s6*  
r13 ------- s4*  
* For welded lattice flooring accepted cell 34 * 38, for pressed – 33 * 33
** Due to technological limitations, not all cell sizes and load-bearing strips can be manufactured with all slip protection options. Our technical specialists and managers will advise you when ordering.